Refurbished RIGblaster Blue (Rev 1)

Buy Now Add to Wish List

Refurbished RIGblaster Blue (Rev 1)

#58000-1480

$150.00

Click for Details

Refurbished RIGblaster Blue (Rev 1) Unit
(1) 1/8" Audio Cables, 6 ft.
(1) 8-pin Screw-on Custom Mic Cable, 3 ft
Instant Setup Connectors
9V DC Power Supply
USB Flash Drive with Device Drivers, Owner's Manual & Collection of Ham Radio Sound Card Software
Accessory Kit

(8) White Jumpers
(5) Blue Shunt Jumpers

Features
Specifications
Contents
Manual
Software

Note: Differences between this refurbished unit and the current unit are bolded below.

Capabilities

Completely Integrated Bluetooth^® Interface

Pairs with a PC to provide a sound device and a rig control serial port. May also work with very old models of tablets and smartphones.
Pairs with a Bluetooth^® headset for receive and transmit. Does not work with all Bluetooth^® headsets.
Less Bluetooth^® range. Bluetooth^® antenna provides less than 33' range.
Uses bi-directional audio Bluetooth^® protocol (HSP & HFP)
PC configuration software included for maximum flexibility

Compatible With Most Ham Radios

Easily configure the RIGblaster Blue for most radios with pre-wired jumper blocks (ISC)
Seven ISCs included. Covers most Icom, Yaesu, Kenwood, Elecraft & Alinico radios.
Adds Bluetooth^® capabilities out-of-the-box to any radio that uses an 8 pin round or RJ-45 modular mic jack.
Optional cables available for 6 pin RJ-25 and 4 pin round mic jacks

Built-in Rig Control

TTL Icom (CI-V)/Yaesu (CAT) interface jack
RS-232C with DB-9 connector provided

Front Panel Audio Controls

XMIT Level allows accurate drive to transmitter
RCV Level adjusts headset volume and waterfall brightness

TX Control

Audio VOX (with adjustable delay) allows for simple configuration
PTT inhibit for listen only
Red LED provides visual feedback of PTT status

Other Great Features

Easy Bluetooth^® operation with 3 position selector: Config, PC & Headset mode.
Bluetooth^® pairing status LED
Rear panel RCA PTT jack for use with footswitch or external sequencer
Fully isolated transformer coupled Audio
Isolated PTT (mechanical relay)
Two external speaker jacks for receive and transmitted Audio
Excellent RF/noise immunity
USB flash drive of sound card software collection

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Bluegiga Technologies is under license. Other trademarks and trade names are those of their respective owners.

Specifications

Overall Dimensions (maximum w/o cables)	1 1/4" H x 6 1/4" W x 4" D
Weight	24 oz.
PTT Max Contact Rating	2A @ 24V or 1A @ 48V
Interface	Bluetooth^® Wireless Technology
TTL Rig Control Interface Port (dual circuit mini jack connector)	Standard TTL 5V logic, selectable bi-directional or unidirectional

The microphone audio is completely isolated from all other grounds.

The PTT relay provides adequate current and voltage capability to switch tube rigs.

Includes

Refurbished RIGblaster Blue (Rev 1) Unit
(1) 1/8" Audio Cables, 6 ft.
(1) 8-pin Screw-on Custom Mic Cable, 3 ft
Instant Setup Connectors
9V DC Power Supply
USB Flash Drive with Device Drivers, Owner's Manual & Collection of Ham Radio Sound Card Software
Accessory Kit

(8) White Jumpers
(5) Blue Shunt Jumpers

A USB flash drive of the RIGblaster Software Collection is the standard media. If you are unable to use a USB flash drive, you may request the software on a DVD or three (3) CD Set. When ordering online, in the comments section of the order form, type in "Request DVD" or "Request 3 CD Set". Alternately, the collection of software programs may be individually downloaded here.

The owner's manual is available in PDF format on the USB flash drive and online. If you require a printed manual, request "Printed Manual" in the Notes section of the online order.